Foxconn M7PMX Series - Manual (Page 82)

75
5
5-2 RAID enable in bIoS
1. Enter the BIOS setup by pressing key when boot up.
2. Select the “Integrated Peripherals” from the “Main menu”, then select the
“MCP
SATA Mode” menu and press to go to the configuration items.
3. Enable RAID function and individual SATA port for hard drive or DVD connection.
4. Press to save the setting then PC will reboot itself.
5-3 Select a RAID Array for Use
When BIOS is restarted, it will display a message asking you to press [F10] key to
enter the main menu of MediaShield BIOS. Press [F10], the screen appears.
At the bottom of each screen displayed, there is one line listing each key’s function,
such as , , ...etc. It is helpful to make your choice easier.
MediaShield BIOS Jul 27 2007
- Define a New Array -
RAID Mode: Mirrored Stripe Block: Optimal
Free Disks Array Disks
Port Disk Model Capacity Port Disk Model Capacity
[+] Add
[ESC] Quit [F6] Back [F7] Finish [TAB] Navigate [↑↓] Select [Enter] Popup
0.0 WDC WD1200JD-9 111.79GB
0.2 Hitachi HDT725 232.88GB
0.1 HDS728080PLA38 76.69GB
0.3 ST3320620AS 298.09GB
Mirrored Optimal
0.0 WDC WD1200JD-9 111.79GB
Phoenix - AwardBIOS CMOS Setup Utility
MCP SATA Mode
SATA Operation Mode [ RAID ] Item Help
SATA Pri-Master RAID [Enabled]
SATA Pri-Slave RAID [Enabled] Menu Level ►
SATA Sec-Master RAID [Enabled]
SATA Sec-Slave RAID [Enabled]
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F7:Optimized Defaults
RAID