Foxconn 865G7AF-8EKS - Manual (Page 26)

Chapter 2 Installation Instructions
20
1
TPB-
IrDA Connector: IR
This connector supports wireless transmitting and re-
ceiving device. Before using this function, configure
the settings of IR Mode from the “Integrated Peripher-
als” section of the CMOS Setup.
IR
1394 Connector: F_1394 (Optional)
The 1394 expansion cable can be connected to either
the front (provided that the front panel of your chassis
is equipped with the appropriate interface) or rear
panel of the chassis.
GND
+12V
GND
TPA -
F_1394
1 2
9 10
+12V
TPB +
GND
Empty
TPA +
+5V
GND
IRRX
IRTX
Empty
1. You must install the driver before you use the USB 2.0 function.
2. NEVER connect a 1394 cable to the F_USB1 or F_USB2
connectors. Doing so will damage the motherboard!
USB Connectors: F_USB1, F_USB2
Besides four USB ports on the rear panel, the series of motherboards also have
two 10-pin connectors on board which may connect to front panel USB cable
(optional) to provide additional four USB ports.
Note:
1 2
VCC
D6+
D6-
Empty
GND
NC
D7+
D7-
GND
VCC
10 9
F_USB 2
1 2
VCC
D4+
D4-
Empty
GND
NC
D5+
D5-
GND
VCC
10 9
F_USB 1