Foxconn 865G7AF-8EKS - Manual (Page 24)

Chapter 2 Installation Instructions
18
Reset Switch (RESET)
Attach the connector to the Reset switch on the front panel of the case; the
system will restart when the switch is pressed.
Power LED Connector (PWRLED)
Attach the connector to the power LED on the front panel of the case. The Power
LED indicates the system’s status. When the system is in S0 status, the LED is
on. When the system is in S1 status, the LED is blink; When the system is in S3,
S4, S5 status, the LED is off.
Power Button Connector (PWRSW)
Attach the connector to the power switch of the case. Pushing this switch allows
the system to be turned on and shut down.
Fan Connectors : CPU_FAN, FAN1
The fan speed of CPU_FAN and FAN1 can be
detected and viewed in “PC Health Status” sec-
tion of the CMOS Setup. These fans will be auto-
matically turned off after the system enters S3,
S4 and S5 mode.
Audio Connectors: CD_IN, AUX_IN (optional)
CD_IN, AUX_IN is Sony standard CD audio
connectors, it can be connected to a CD-ROM
drive through a CD audio cable.
S-ATA Connectors: SATA_1, SATA_2
The S-ATA connector is used to connect the S-
ATA device to the motherboard. These connec-
tors support the thin Serial ATA cables for pri-
mary internal storage devices. The current Se-
rial ATA interface allows up to 150MB/s data trans-
fer rate, faster than the standard parallel ATA with
133MB/s (Ultra ATA 133).
SATA _1/SATA _2
GND GND GND
T X+
TX-
RX+
RX-
FAN1
+12V
GND
1
SENSE
POWER
GND
CONTROL
SENSE
1 CPU_FAN
CD_IN
CD_L
GND
CD_R
1
AUX_IN
AUX_R
GND
AUX_L
1
1