Foxconn 865G7AF-8EKS - Manual (Page 25)

Chapter 2 Installation Instructions
19
Front Audio Connector: F_AUDIO (for -6
models)
The audio interface provides two kinds of au-
dio output choices: the Front Audio, the Rear
Audio. Their priority is sequenced from high
to low (Front Audio to Rear Audio). If head-
phones are plugged into the front panel of
the chassis (using the Front Audio), then the
Line-out (Rear Audio) on the rear panel will
not work. If you do not want to use the Front
Audio, pin 5 and 6, pin 9 and 10 must be
SHORT, and then the signal will be sent to
the rear audio port.
Chassis Intruder Connector: INTR
The connectors connect to the chassis security switch
on the case. The system can detect the chassis intru-
sion through the status of this connector. If the connec-
tor has been closed once, the system will send a
message. To utilize this function, set “Intruder# Detec-
tion” to “Enabled” in the “Power Management Setup”
section of the CMOS Setup. Save and exit, then boot
the operating system once to make sure this function
takes effect.
SPDIF_Out Connector: SPDIF_OUT
The SPDIF out connector is capable of providing digital
audio to external speakers or compressed AC3 data to
an external Dolby digital decoder.
Note: The empty pin of SPDIF cable should be aligned
to empty pin of SPDIF out connector.
Front Audio Connector: F_AUDIO (for -8
models)
The audio interface provides two kinds of au-
dio output choices: the Front Audio, the Rear
Audio. Their priority is the same. Front Audio
supports re-tasking function.
F_AUDIO
MIC_IN MIC_GND
MIC_PWR +5VA
AUD_OUT-R AUD_RET-R
NA Empty
AUD_OUT-L AUD_RET-L
1 2
9 10
F_AUDIO
PORT1_L AUD_GND
PORT1_R PRESENSEJ
PORT2_R SENSE1_RETURN
SENSE_SEND Empty
PORT2_L SENSE2_RETURN
1 2
9 10
INTR
INTRUDERJ
GND
2 1
SPDIF_OUT
1
SPDIF_OUT
+5V
GND
Empty