Audio header: f_audio, Spdif out header : spdif_out, Speaker header: speaker – Foxconn H97M Plus User Manual
Page 23: Lpt hearder : lpt, Fan headers: cpu_fan, sys_fan, Hardware installation 16, The header is used for spdif output
HARDWARE INSTALLATION
16
Audio Header: f_AUDIO
The audio header supports HD Audio standard.
It provides the Front Audio output choice.
SPDIf OUT Header : SPDIf_OUT
The header is used for SPDIF output.
Speaker Header: SPeAKeR
The speaker header is used to connect speaker
of the chassis.
LPT Hearder : LPT
The header supports parallel port which can
be connected to a printer or a scanner. System
usually assign IRQ7 as it’s default interrupt
request and the parallel port has three operation
mode: [SPP], [EPP], [ECP].
fan Headers: CPU_fAN, SYS_fAN
There are two main fan headers on this moth-
erboard. The fan speed can be controlled and
monitored in “ Health” section of the BIOS Set-
up. These fans can be automatically turned off
after the sytem enters S3, S4 and S5 sleeping
states.
Strobe
Auto Feed
1 2
25 26
Error
SLCT IN
INIT
Ground
Ground
Ground
Ground
Ground
Ground
Ground
Ground
Empty
Data it [0]
Data it [1]
Data it [2]
Data it [3]
Data it [4]
Data it [6]
Data it [5]
Data it [7]
ACK
Busy
Paper End
Select
LPT
+5V
EMPTY
SPDIF_OUT
GND
SPDIF_OUT
1
2
3
4
A_MIC2_L
A_MIC2_R
A_LINE2_L
SENSE_SEND
SENSE1_RETURN
PRESENCEJ
EMPTY
SENSE2_RETURN
AUD_GND
1 2
10
9
F_AUDIO
A_LINE2_R
SPEAKER
NC
PWR
EMPTY
SPKJ
1
CPU_FAN/SYS_FAN
SENSE
POWER
GND
CONTROL
1