Foxconn K8T890M2AA-KRS2H - Manual (Page 18)

11
Chapter 2 Installation Instructions
IrDA Header: IR
This connector supports wireless transmitting
and receiving device. Before using this function,
configure the settings of IR Address, IR Mode
and IR IRQ from the “Integrated Peripherals”
section of the CMOS Setup.
USB Headers: F_USB1, F_USB2
Besides four USB ports on the rear panel, the
series of motherboards also have two 10-pin
header on board which may connect to front
panel USB cable (optional) to provide addi-
tional four USB ports.
1
IR
+5V
GND
RX
T X
E m p t y
F_USB1/2
VCC
D+
D-
Empty
GND
NC
D+
D-
GND
VCC
Fan Connectors: CPU_FAN, SYS_FAN
The speed of CPU_FAN and SYS_FAN can be detected and viewed in “PC Health
Status” section of the CMOS Setup. These fans will be automatically turned off
after the system enters suspend mode.
Audio Connectors: CD_IN, AUX_IN (optional)
CD_IN, AUX_IN is Sony standard CD audio connector, it can be connected to a
CD-ROM drive through a CD audio cable.
AUX_IN
AUX_L
GND
AUX_R
1
CD_IN
CD_L
GND
CD_R
1
CPU_FAN
POWER
GND
1
CONTROL
SENSE
SYS_FAN
SENSE
POWER
GND
1
CONTROL
PDF 文件使用 "pdfFactory" 试用版本创建 Æ Æ www.fineprint.com.cn