Foxconn K8T890M2AA-KRS2H User Manual
Page 17
Chapter 2 Installation Instructions
10
Other Connectors
This motherboard includes connectors for FDD device, IDE device, Serial ATA
devices, USB devices, IR module, and others.
FDD Connector: FLOPPY
This motherboard includes a standard FDD connector, supporting 360K, 720K,
1.2M, 1.44M, and 2.88M FDDs.
HDD Connectors: PIDE & SIDE
This motherboard provides two IDE connectors which support Ultra DMA 133/
100/66 IDE hard disk ribbon cable. Connect the cable’s blue connector to the
primary (recommended) or secondary IDE connector, then connect the gray
connector to the Ultra DMA 133/100/66 slave device (hard disk drive) and the
black connector to the Ultra DMA 133/100/66 master device.
Front Panel Connector: FP1
This motherboard includes one connector for connecting the front panel switch
and LED indicators.
Hard Disk LED Connector (HDD_LED)
The connector connects to the case’s IDE indicator LED indicating the activity
status of IDE hard disk.
Reset Switch (RESET)
Attach the connector to the Reset switch on the front panel of the case; the
system will restart when the switch is pressed.
Power LED Connector (PLED)
Attach the connector to the power LED on the front panel of the case. The Power
LED indicates the system’s status. When the system is in S0 status, the LED is
on. When the system is in S1 status, the LED is blink; When the system is in S3,
S4, S5 status, the LED is off.
Power Swith Connector (PWRBTN#)
Attach the connector to the power button of the
case. Pushing this switch allows the system
to be turned on and off rather than using the
power supply button.
NC
HDD_LED R E S E T
PLED PW RBTN#
1 + -
+ -
FP1
PDF 文件使用 "pdfFactory" 试用版本创建