Formax FD 130 User Manual
Page 9
7
b. GENTLY pull tractor to the left to eliminate any sagging of the forms - - -
forms must be taut between the tractors. Lock the left tractor in place by
pushing down on the locking lever. (See Figure 8)
NOTE:
Continuous forms of some manufacturers may vary in width from box to
box or even within the same box. Whenever loading continuous forms,
always check to make sure that the feeder strips line up with the tractor pins
AND that the paper is taut between the tractors.
5.
Close cover on machine. LOCK and REMOVE key.
6.
Press [ENTER] and then [START] and allow approximately 12 forms to run
through the machine. Press [PAUSE].
a. Make sure that the checks are stacking properly at the rear of the
machine. The first form should be pointing toward the rear of the machine.
If not, manually refold the forms along the natural fold lines. Place the
stack of refolded forms about 6" from the rear of the machine.
b. Press [START] and sign forms. The machine will stop automatically when
the last form has been signed.
FOR AN OPTIMUM SIGNING OPERATION IT IS SUGGESTED THAT:
• A STACK OF FORMS NO HIGHER THAN 4" BE PROCESSED IN ONE
RUN.
• THE SIGNER BE MOUNTED ON A SUITABLE STAND THAT ALLOWS
THE SIGNED DOCUMENTS TO "DROP" FREELY BELOW THE BASE
OF THE SIGNER
Figure 8
Locking
Left
Tractor