Formax FD 130 - Manual (Page 14)

12
HELP CODES
If a help code should appear during operation take the following action. If help code
re-appears after you have taken the suggested action, call for service.
HELP 1 START button pressed with paper in sensor.
H E L P 1 : P a p e r S e n s o r
B l o c k e d P r e s s [ E N T E R ]
ACTION: Remove and reload forms as described on Page 5. Press [ENTER]
and then [START] to start signing.
HELP 2 Cannot find home flag at start.
H E L P 2 : S i g n a t u r e S h a f t
H ome F l a g N o t F o u n d
ACTION: Check to see that the signature shaft rotates freely. Press [CAN-
CEL] then press [ENTER] and then press [START]. If HELP 2 appears again
call for service.
HELP 4 Top cover open.
H E L P 4 : S i g n a t u r e P l a t e
C o v e r I s O p e n
ACTION: Insert key in top cover lock as shown in Figure 1 and lock cover.
HELP 5 No paper sensed.
H E L P 5 : N o P a p e r F o u n d
C h e c k P a p e r F e e d
ACTION: Check to see if forms are correctly loaded into the machine. If
they are, remove and reload forms. Press [CANCEL], then [ENTER] and
then [START] to begin signing.
HELP 9 Printing stopped by power failure.
H E L P 9 : P r i n t i n g S t o p p e d
B y P ower L o s s
ACTION: Correct the power problem. Press [CANCEL] and record audit and
batch counter values.
HELP 11 Invalid number entered.
H E L P 1 1 : I n v a l i d V a l u e
R a n g e : 1 T o 1 0
ACTION: Verify that the number you have entered is between 1 and 10 and
then re-enter the number.
If a HELP 6, HELP 7, HELP 12, HELP 14, HELP 15, HELP 16 or a HELP 17 appears,
call for service. There is no corrective action you can take and attempting to operate
the machine may result in damage or loss of data.