Formax FD 130 - Manual (Page 4)

2
PASSWORD
•If a password is not required the following screen will not appear, proceed
directly to Step 6.
•If a password is required the following screen will be displayed:
4. Press [1] thru [10] digit keys to enter password. An " * " will appear on the
display for each digit entered. Press [Cancel] to cancel an entered number.
Press [ENTER] to enter a keyed password.
P a s swor d :
[ E N T E R ] T o A c c e p t
5. If the password is not valid press [CANCEL] to return to Password screen.
A C C E S S D E N I E D
P r e s s [ C A N C E L ]
SELECT ACCOUNT
The following screen will appear when a password is accepted or if a password is
not required it will appear when machine is turned on.
6. Either press [ENTER] to accept Account 1, or press [2] thru [10] and then
[ENTER] to select another account. Press [CANCEL] to cancel an
entered number.
S e l e c t A c c o u n t N umber 1
[ E N T E R ] T o A c c e p t
READY
The following screen will appear after [ENTER] has been pressed.
A c c o u n t ## B a t c h 0
R E A D Y A u d i t ##### ##
SIGNING FORMS
7. Load forms as described on Page 5. Check that the leading edge does not
protrude into the opto sensors. Press [START] to begin signing.
A c c o u n t ## B a t c h #####
S I G N I N G A u d i t ##### ##
PAUSE
8. Press [PAUSE] to temporarily stop signing forms. Press [START] to resume
signing.
A c c o u n t ## B a t c h #####
P A U S E D A u d i t ##### ##
NOTE: If the signer remains in [PAUSE] longer than four (4) minutes it will
go to [FINISHED] as described in Step 9. To restart, the forms must be
removed from the signer. Then press [CANCEL] or [ENTER] to return to
the Select Account screen as shown in Step 6.