Formax FD 260-10 - Manual (Page 24)

20
3. Pull the FUSE DRAWER out of the POWER
ENTRY CASING. The LINE FUSES are inside.
4. Determine the proper fuse value as well as the
condition of the LINE FUSE. The fuse value is
shown on the metal tip of the LINE FUSE. The
chart below lists the selected voltage in the left
column followed by the proper fuse value in the
right column.
Selected Voltage Line Fuse Value
100V…………………….1.0A (250V time delay)
120V…………………….1.0A (250V time delay)
220V…………………….0.5A (250V time delay)
240V (or 230V)…………0.5A (250V time delay)
5. Replace the LINE FUSE if necessary. Both LINE
FUSES must be intact for the FD 260-10 to
operate properly.
6. Install the FUSE DRAWER in the POWER
ENTRY CASING.
POWER ENTRY
FUSE
FUSE DRAWER
APPLIANCE INLET
LOCKING TAB
CASING
VOLTAGE
SELECTOR
WINDOW
FUSE DRAWER
POWER CORD
VOLTAGE
SELECTOR
Figure 6.1 -- FD 260-10 Power Connection