Formax Cut-True 22S - Manual (Page 8)

Blade holder
There are 5 screws for positioning the blade on the blade holder.
Blade
It’s made of high quality carbon steel and needs to be installed and removed step by step following the
blade replacement instructions.
Cutting Stick
It’s made of tough plastic to protect the edge of the blade. Each of its four sides can be used.
Safety Guard
The safety guard must be closed properly before cutting, so the interlock device will be released.
Select switch:
Turn it to the right for conducting cutting procedures, and turn it to the left for blade replacement
procedures. Keep it in the middle to stop all operations.
Safety Guard System(Interlock Device)
Interlock device A: The machine can be operated only when the safety guard is closed completely.
Interlock device B: : For the safety reasons, the machine cannot be operated when the 5 mm T wrench is
still in the blade adjustment device.
Clamp Hand Wheel
Turn it clockwise to clamp the stack of paper tightly.
Cover
Attached to the machine with two screws. You are only allowed to remove it for changing the blade or
doing maintenance.
Carrier(Cutter Base)
It’s purpose is to carry the blade holder and the entire mechanism.
Back-gauge
It’s controlled by the back-gauge crank which can be adjusted to the desired cutting size and parallel align
the stack of the paper to be cut.
1
2
3
6
9
10
4
5
7
8
Getting to know your paper guillotine:
06
7
8
18
4
15
19
5
14
5
15
20
9
11
10
2
1
3
13
12
17
16
6A
6B