Formax Cut-True 22S - Manual (Page 10)

Blade Replacement Procedure
1. Turn the power switch ON, and turn the select
switch to the left.
2. Press two enable switches simultaneously to
move the blade down to the bottom position.
3. Turn the select switch to the middle and turn
off the power. Then lift the plexi safety cover to
remove the first screw from the right side of the
blade (A).
4. Close the safety cover and turn the select switch
to the left. Then turn on the power. The blade will
move up automatically. Turn the select switch to
the middle and turn off the power.
5.
Raise the safety cover and remove the first
screw from the left side (B). Remove the screws
to the left and right of center (C & D), but leave
the center screw in place.
NOTE: Do not remove the center screw.
Power switch in ON position
Select switch in blade change position
Center screw
A
B C
D
8