Formax FD 125 - Manual (Page 9)

Page 9
INSTALLATION
1. CUTTER INSTALLATION
Note: No tool is required for installation.
Stand
Place the machine on the stand. Make sure to align the pins
on the stand to the holes on the base plate of the machine.
The door of the stand should face the operator side.
Stack Tray
Place the left guide, center guides and right guide as shown.
Power Cord
Use caution when plugging in power cord. Attach power cord
to the machine and plug the other end into the wall outlet.
SETTING UP PROCEDURE
1
To set the width of paper, loosen thumbscrew knob on
the side guide and slide to position. Use scales as
reference point.
2
Fan paper before loading. This will reduce static and
toner adhesion due to printing. For best result, the
paper stack should be flat.
Thumbscrew
knobs
Paper feed guides
Scales
Center
guides
Pins
Left
guide
Right
guide