Formax FD 125 - Manual (Page 10)

Page 10
3
Push the feed tray down and load the paper. Readjust
paper guides if needed.
4
Adjust tray pressure. For thinner paper, the number
should be higher. For heavier paper the number should
be lower.
5
Use slitter registration adjustment knob to compensate
for printing registration. The knob will allow ± 2mm of
adjustment left and right.
6
Auxiliary roller is for hard-to-feed paper. To use auxiliary
roller, load paper, then push the rollers down onto paper.
7
Adjust feed rollers so they are about 0.5” away from the
edge on each side of the paper.