Formax FD 125 - Manual (Page 18)

Page 18
CUT MARK
The purpose of the cut mark is to compensate horizontal cut due to image shifting during printing.
Hold and press to enable or disable cut mark. This will toggle “M” for mark and “NM” for no mark on the
display.
TURBO AND NORMAL MODE
1. Hold for 4 seconds.
2. Press to select “Normal Mode” or “Turbo Mode (Default)”.
3. Press to save settings.
# Paper weight above 300 gsm set it to “Normal Mode”
PAPER WEIGHT
Adjust paper weight settings if paper is skewing or misfeeding.Set 1 or 2 for lighter paper and 4 or 5 for heavier paper.
1. Hold for 4 seconds.
2. Press to select settings 1-5. Use table below for references.
3. Press to save settings.
Setting Paper Weight
1, 2 120 – 210 (gsm)
3 211 – 300 (gsm)
4, 5 301 – 350 (gsm) (Normal Mode)