Dukane 28A8932 User Manual

Page 41

Balance

The

Balance

setting controls the balance between the left and

right speakers. The

Balance

setting applies to all sources you have

connected.

•

Press the left mouse button to increase the amount of sound
coming from the left speaker; press the right mouse button to
increase the amount of sound coming from the right speaker.

Fade

The

Fade

setting controls the balance between the internal and

external speakers. The setting appears gray and won’t highlight if
external speakers aren’t connected.

•

Press the left mouse button to increase the amount of sound
coming from the internal speaker; press the right mouse button
to increase the amount of sound coming from the external
speakers.

Audio Source Select

This setting allows you to match a computer or video input to an
audio input. The projector has four computer and three video
inputs, but only four audio inputs.

NOTE: Audio cables must be con-

nected in order to hear sound from

the projector.

Select among audio sources 1, 2, and 3, and Cable . (The
Cable computer input does not have a separate audio
input. Audio is transmitted in the Cable computer input.)
By default, the RGBHV and M1-DA sources are assigned to audio
input 1, the VESA source to audio 2, the Cable source to
Cable , and all video sources to audio 3. (Figure 8 on page
10 shows the labeled audio inputs on the connector panel.) To
change these assignments, make the desired source active (for
example, the VESA input), then select an audio source.

Hub