Formax MailDoc Professional Installation/Setup Guide, Rev. 2 - Manual (Page 29)

• N of M: Security feature that ensures the correct number of sheets are accumulated and inserted. N = the
sheet # and M = the # of sheets in each set. If N is less than M another sheet is pulled, if N is equal to M the
set is complete and inserted, and If N is great than M a sequence error is generated and the group is diverted.
• Sheet Sequence – A sheet sequence mark is used as a sheet counter, if a sheet number is missing, an error
is generated..
• Group Sequence – A group sequence mark is used as a set counter, if a set number is missing, an error is
generated..
• Insert – An insert mark has the inserter feed a sheet from the station specified.
• Accumulate – An accumulate mark indicates that a set is complete and is ready to be inserted.
• Divert/Cont – A divert/cont mark ejects the set to the divert tray and continues operation.
• Divert/Stop – A divert/stop mark stops the system from collating and ejects the set to the divert tray.
• Sel. Feed – Tells the inserter to pull a sheet from a specified feeder based on criteria entered.
• Sealing - If automated sealing is available on the inserter this mark will indicate that the envelope should not
be sealed.
• Exit Set - If multiple exit options are available this mark can be used to direct where the finished mail piece is
ejected from the inserter.
• Env. Hopper - If multiple envelope hoppers are available on the inserter this mark will indicate which envelope
hopper to pull from.
• Customer ID – The customer ID mark is used in place of the N of M or insert accumulate mark. If the
customer ID is the same as the previous page it will accumulate if the Customer ID is different then the
previous set it will insert the set.
• Display Barcode Number – Enables the display of the code numbers within the barcode.
• Rotation Angle – Sets the angle of the barcode, horizontal, vertical, left to right, right to left, top to bottom or
bottom to top.
• Max # of Pages (OMR/BCR) – Used to set a value
• Pitch (BCR Only) – Used to set the Ratio of think to thin lines of the barcode (Typically set to 2.3 for Formax
branded inserter systems)
• Barcode Type (BCR only) – Check operator manual of inserter to see which code can be read
1D – Single Dimensional barcodes 2D – 2 Dimensional barcode
25