Formax FD 6102 - Manual (Page 16)

15
ENGLIS
H
3.5 Filling the Sealing Liquid Reservoir
When you want to seal envelopes,
the sealing liquid reservoir must be
filled.
1. Press the button to open
the system (see “Operating
Controls” on page 7).
2. Lift the sealing liquid reservoir
D with the blue handles A
carefully out of the system.
3. Remove the strip C from the
reservoir.
4. Fill the three reservoirs with
sealing liquid.
5. Make sure the brushes B are
moistened sufficiently.
6. Replace the liquid reservoir.
7. Close the system.
Before you start the job, wait
approximately 5 minutes for the
brushes to moisten.
3.6 Run a Job
Note
Before you run a job, make sure the sealing liquid reservoir is filled.
To run a job:
1. From the home menu choose a job.
The job information appears (see “Job
Description (Current Job)” on page 9).
2. Load envelopes as specified in the job.
3. Load the documents face up and trailing, as
specified in the job.
Place the address carrier in feeder 1.
4. Press the 1x button to start a test run or
press the button to start the job.
If you press the 1x test button, the system helps you to adjust the address position
(see 6.3.7 ”Address Position” on page 26).