Formax FD 2052IL System - Manual (Page 11)

7
4. Press the “Fold Setup” button to automatically
set the fold plates (Fig. 14).
Printer Paper
Orientation Guide
OPERATION
1. Plug in cord and turn power on for both the
pressure sealer and the laser printer.
2. Set the form length by flipping the 11”/14”
toggle switch located below the feed deck on the
operator side (Fig. 12)
3. Select the fold type from the “Standard Fold
Menu” (Fig.13). If a custom fold is being used
select fold from the Custom fold Menu (see pg 9
to set a custom fold.)
5. Place pressure seal forms in printer paper tray.
Paper should be loaded into the approved HP
printers face down with the glue edge trailing.
Locate the paper orientation guide on the printer
and load accordingly (Fig. 15). The print side
glue edge is considered the top of the document.
Once forms are loaded perform an offline print
test (see pg. 8) to make sure the printer and
sealer are aligned properly. If the print test is
satisfactory begin online operation.
Form Length Switch
Standard Fold
Selection Button
Fold Setup Button
Fig. 14
Fig. 13
Fig. 12
Fig. 15