Formax FD 2002 - Manual (Page 10)

OPERATION
1. Place power switch in the “ON” position.
2. After determining the fold type (see pg 6
“Determining Fold Type”) set the Upper and Lower
fold plates.
To set the fold stop position, squeeze the fold stop
lever and move the fold stop to the desired location
on the upper and lower fold plates(Fig 4). Align the
pointed part of the stop plate with the desired marks
on the decal and release the lever. Fine adjustments
can be made with the adjustment knob at the end of
the plate (Fig 5).
NOTE: When doing a “Half” fold, remove the bottom
fold plate, turn it 180 degrees and insert with the fold
deflector leading (Fig 6). The plate must be firmly
reinstalled on the locating pins.
5a. Set the catch tray (See step 5b if using a conveyor).
Slide the catch tray in or out to align the appropriate
fold/form setting on the “Fold/form size decal” with
the alignment decal located on the non-operator side
frame
(Fig 7a).
5b. Set the conveyor out feed wheels. Align the center of
the out-feed stacker wheels with the appropriate fold/
form setting on the “Fold/form size decal” (Fig 7b).
Fig. 5
6
Fig. 4
Fig. 6 Fold Deflector
Fig. 7a
Alignment Decal
Fold/Form Size Decal
Fold/Form Size Decal
Fig. 7b