Fluke Biomedical 1060AM - Manual (Page 19)

Operation
Terminal Operation
3
3-3
NOTE
RRS r Read mR/Hr (latest second mR/Hr value)
RSH r Read Sieverts (averaged over 60 minutes)
RSM r Read Sieverts (averaged over 60 seconds)
RSS r Read Sieverts (latest second Sievert value)
RTA Read TAU (deadtime)
SCx s Set Conversion Factor x, where x = 0 to 9
*SCR s Set Conversion Factor CPM to mR/Hr (enter CPM per mR/hr)
SDO Set Digital Output (Sets 16 digital outputs)
SFD s Set output Format Decimal (integer)
SFE s Set output Format Engineering (default, x.xxExx)
SFH s Set output Format Hex (integer, 16 hex digits)
SGT s Set GM Threshold (Sets Thresh., stores in EEPROM)
SHD s Set High Discriminator (Sets Hi Discrim., stores in EEPROM)
SHS s Set High Scale analog output (entered in units of mR/hr)
SHV s Set High Voltage (Sets HV, stores setting in EEPROM)
SIC s Set Input Control
SID s Set unit Identification
SLD s Set Low Discriminator (Sets Lo Discrim., stores in EEPROM)
SLS s Set Low High Scale analog output (enter in units of mR/hr)
*STA s Set TAU (deadtime correction);
VER Read firmware Version and Revision level
XSM s Exit Setup Mode
XTM t Exit Test Mode
Commands SCR and STA must be used to enter
the CPM to mR/hr conversion factor and deadtime
correction. These values must be entered
whenever a new detector is installed. These values
can be found on the detector calibration sheet.
3.3 LED Definitions
1. Heartbeat (flash pulse indicates proper operation)
2. HV ON
3. RS-232 (Port 1) Command accepted and processed
4. RS-232 (Port 1) Character received
5. RS-485 (Port 2) Command accepted and processed
6. RS-485 (Port 2) Character received
7. RS-485 (Port 3) Command accepted and processed
8. RS-485 (Port 3) Character received
3.4 DIP Switch Definitions
1. ON = HV ON
2. ON = Port 1 (RS-232) Setup commands available
3. ON = Port 2 (RS-485) Setup commands available
4. ON = Port 3 (RS-485) Setup commands available
5. Open
6. Open