Flowserve VKP 40Ex - Manual (Page 15)

5
Data Exchange between PC and Data Collector VKPN 40Ex or VKPN 40
The menu Data Collector enables the communication between the data collector and the PC and the organization of the data collector
via PC. For more information refer to section “Transferring test tasks to data collector”, “Deleting test tasks for data collector” and
“Transferring test results from data collector to PC” in the Online Documentation of the PC program.
Make sure that the data collector is connected and ready for use and then select the submenu “Data exchange” of the main menu of
the data collector (“Connecting and Commissioning” see pages 0 – ).
When selecting the menu “Data exchange” the following display appears:
During a data exchange information on the transferred data is also indicated:
“Tasks to VKPN” (if test tasks are transferred to the data collector) or
“Delete task” (if test tasks are deleted on the data collector).
During the data transfer the following display appears:
■
If the power supply unit is not connected the data collector cannot communicate with the PC.
Attention
■
A safety protocol is created in order to prevent any loss of data during the transfer.
Consequently, the transfer rate can vary between 30 seconds and 1.5 minutes for 100 steam traps .
Once the data transfer is completed the display “Waiting for data” appears.
Press the ENTER key to return to the main menu of the data collector.
Note
Number of test objects still
to be transferred
Total number of all test objects
for the test task in process
No. of the test task that is being
transferred