Datalogic Scanning QUICKSCAN QD 2300 - Manual (Page 39)

RS-232 Parameter Defaults
Product Reference Guide 33
RS-232 Parameter Defaults
Table 5 lists the defaults for RS-232 host parameters. If any option needs to be changed,
scan the appropriate bar code(s) provided in the Parameter Descriptions section begin-
ning on
page 33 .
RS-232 Host Parameters
Various RS-232 hosts are set up with their own parameter default settings ( Table 6 ). Se-
lecting the ICL, Fujitsu, Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, Olivetti,
Omron, or terminal sets the defaults listed in
Table 6 .
Selecting the ICL, Fujitsu, Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, OPOS
terminal enables the transmission of code ID characters listed in
Table 7 on page 34 .
These code ID characters are not programmable and are separate from the Transmit
Code ID feature. The Transmit Code ID feature should not be enabled for these termi-
nals.
NOTE
See Appendix B, Standard Defaults for all user preferences, hosts, symbolo-
gies, and miscellaneous default parameters.
Table 5. RS-232 Defaults
Parameter Default Page Number
RS-232 Host Parameters
RS-232 Host Types Standard 36
Baud Rate 9600 37
Parity Type None 38
Stop Bit Select 1 Stop Bit 39
Data Bits (ASCII Format) 8-Bit 39
Check Receive Errors Enable 40
Hardware Handshaking None 42
Software Handshaking None 44
Host Serial Response Time-out 2 Sec 45
RTS Line State Low RTS 46
Beep on Disable 46
Intercharacter Delay 0 msec 47
Nixdorf Beep/LED Options Normal Operation 48
Ignore Unknown Characters Send Bar Code 48