User general feature defaults – Datalogic Scanning QUICKSCAN QD 2300 User Manual
Page 26
General Features
20
QuickScan
®
L
User General Feature Defaults
Table 4
lists the factory defaults for the general features described in this chapter, plus
provides a place for you to log any special requirements or user-preferred settings at your
installation. To change any option, scan the appropriate programming bar code(s) pro-
vided in this chapter.
Table 4. General Feature Defaults
NOTE
See
Appendix B, Standard Defaults
for a listing of all programmable
features.
General Feature
Standard Factory
Default
Page Number
Record Your Setting
Beeper Tone
Medium
22
Beeper Volume
High
22
Power Mode
Continuous On
23
Scanning Mode
Trigger Single
23
Scan Line Width
Full Width
25
Laser On Time
3.0 Sec
25
Beep After Good Decode
Enable
26
Transmit Label ID Character
None
26
Prefix Value
7013
27
Suffix Value
7013
27
Scan Data Transmission Format
Data as is
26
FN1 Substitution Values
Set
30
Transmit “No Read” Message
Disable
30