Flowserve T-series Thrust Bearing Pot - Manual (Page 23)

USER INSTRUCTIONS T-SERIES THRUST BEARING POT ENGLISH 26999907 01-2013
Page 23 of 24 flowserve.com
8.5 General arrangement drawing
The typical general arrangement drawing and any
specific drawings required by the contract will be
sent to the Purchaser separately unless the
contract specifically calls for these to be included
into the User Instructions. If required, copies of
other drawings sent separately to the Purchaser
should be obtained from the Purchaser and
retained with these User Instructions.
9 CERTIFICATION
Certificates determined from the Contract
requirements are provided with these Instructions
where applicable. Examples are certificates for CE
marking, ATEX marking etc. If required, copies of
other certificates sent separately to the Purchaser
should be obtained from the Purchaser for retention
with these User Instructions.
10 OTHER RELEVANT
DOCUMENTATION AND MANUALS
10.1 Supplementary User Instruction
manuals
Supplementary instruction determined from the
contract requirements for inclusion into User
Instructions such as for a driver, instrumentation,
controller, sub-driver, seals, sealant system, mounting
component, etc. are included under this section. If
further copies of these are required they should be
obtained from the purchaser for retention with these
User Instructions.
Where any pre-printed set of User Instructions are
used, and satisfactory quality can be maintained
only by avoiding copying these, they are included
at the end of these User Instructions such as within
a standard clear polymer software protection
envelope.
10.2 Change notes
If any changes, agreed with Flowserve Pump
Division, are made to the product after its supply, a
record of the details should be maintained with
these User Instructions.
10.3 Additional sources of information
Reference 1:
Pump Handbook, 2
nd
edition, Igor J. Karassik et al,
McGraw-Hill Inc., New York, 1993.