Installation (cont.) – Fire Magic 3049 Aurora Infrared Burner Kit Installation User Manual
Page 2

REV 3 - 1302260945
L-C2-280
2
5. The grill is equipped with a heatshield kit for each main burner.
This kit is only functional with the standard main burner, and
must be removed for proper infrared burner operation. Use pliers
to remove the diverter tube by bending in each side and pulling
it outwards (see Fig. 2-1), then reach in and remove the silicone
gasket (see Fig. 2-2).
6. Pull out and completely remove the drip tray from the grill.
7. With the burner valves in the OFF position, pull the valve knobs
from their stems. Use a Phillips screwdriver to remove the control
panel fastener screws on either side of the grill control panel (see
Fig. 2-3). Release the control panel by lifting it slightly and remove
it from the grill. Make sure to retain the screws and fi nish washers
for re-attaching the control panel.
Note: To protect the wiring harness, carefully lift the control panel
away from the frame and let it rest on the attached chain.
8. Lift the heat shield up and inward slightly to clear the diagonal slots
hooked over the oven fi re wall then pull away from the manifold
(see Fig. 2-4).
9. Remove the existing ignitor wire by fi rst sliding the rubber sleeve
back off the ignitor, then pulling the wire to detach from the ignitor.
Next remove the ignitor nut on the control panel side of the fi re wall
with a 9/16 open-end wrench (see Fig. 2-4) and remove the ignitor
box from inside the oven. Remove the rubber sleeve from the wire
and pull the wire through the heat shield and the insulating tube
in the manifold fi re wall. Disconnect the other end of the ignitor
wire from the ignitor module (see Fig. 2-5).
Control panel
Valve
stem
Screw
Fig. 2-3 Remove control panel
Fig. 2-2 Remove silicone gasket
Remove gasket
Fig. 2-1 Remove diverter tube
Use plier
s to remo
ve
Diverter tube
Bend sides
inward
Fig. 2-4 Remove heat shield and old ignitor
Old ignitor
Heat shield
Fig. 2-5 Remove old ignitor wire
Remove wire from
ignitor module
INSTALLATION (cont.)