Fire Magic 3199-60 Electrode Kit Install User Manual
Fire Magic Hardware

1
ELECTRODE KIT INSTALLATION INSTRUCTIONS
FOR FIRE MAGIC BARBECUES
REV A 030405
No. L-C2-10905
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746
REPLACING THE ELECTRODE KIT FOR
SLIDE-IN UNITS
(see over for Regal I Drop-In units)
1. Remove the valve knobs from the face or panel.
2. Remove the screws and finish washers securing
the face.
3. Carefully remove the face or top panel.
CAUTION: The spark generator may be attached
to the face or panel. Carefully unplug the wires from
the spark generator before pulling away from the
unit.
4. Remove the nuts and the screw securing the old
electrode kit to the barbecue liner and remove the
old kit.
5. If the old collector box has a mounting bracket which
attaches it to the barbecue liner, remove this along
with the old collector box, then go to step 6.
6. Attach the new electrode kit and ground (if used) to
the barbecue liner with the adjusting screw, nut and
washer provided, in the method indicated in either
Figures 2 or 3, whichever matches your barbecue
setup. Ensure the new collector box is fitted in the
same position as the old one.
Note: For all setups you will need to bend part of
the collector box upwards along point A (see Figure
1). We recommend you use pliers to start, then use
a flat non-slip surface to bend the metal to the right
angle required, as in Figure 3. The other setup
(Figure 2) may require a smaller bend, as fits the
circumstance. Use the old collector box & bracket
as a reference for the proper bend. When the
collector box is screwed into place, ensure the outer
shoulders rest firmly and squarely on the burners.
Slight bending may occur across point B. This is
normal and allows box to sit in the correct position.
7. Plug the wires into the spark generator (If you have
a 3 plug generator ,green ground wire must go into
the center plug).
8.
Replace the face and knobs.
9.
Check unit for spark.
10. Secure the face to frame with original face screws.
ELECTRODE WIRE
(BLACK)
BBQ INNER LINER
MOUNTING NUT,
WASHER,
& SCREW
GROUND WIRE
(GREEN)
COLLECTOR
BOX
ELECTRODE
MODEL NO. 3199-60
Figure 2
ELECTRODE
WIRE
MOUNTING
SCREW
(SUPPLIED)
BBQ LINER
COLLECTOR
BOX
ELECTRODE
Figure 3
BEND ALONG
THIS LINE
A
B
BENDING MAY
OCCUR HERE
A
B
Figure 1
This manual may not be copied, photocopied, reproduced, translated, or published in any electronic or
machine-readable form in whole or in part without prior written approval of Robert H. Peterson Co.
We reserve the right to amend product
specifications without prior notice.