beautypg.com

Grill maintenance and safety information – Fire Magic Aurora Combined Stand-alone User Manual

Page 7

background image

7

1. The outdoor grill and surrounding area MUST

remain clear of fl ammable substances such as
gasoline, yard debris, wood, etc.

2. The airfl ow through the vent space located below

the control panel must remain unobstructed.

3. When using propane gas:

a. The required ventilation openings in the

enclosure must be clear of debris.

b. The propane cylinder, regulator, and rubber

hose must be in a location not subject to
temperature above 125° F (51° C).

4. The fl ames on each burner burn evenly along

the entire burner with a steady fl ame (mostly
blue). If burner fl ames are not normal, check
and clean the orifi ce and burner/venturi tubes for

insects and insect nests. A clogged tube can
lead to a fi re beneath the grill. A proper fl ame
pattern will ensure safe operation and optimal
performance. Adjust the air shutter as needed
(see AIR SHUTTER ADJUSTMENT).

5. The in-line gas valve or gas cylinder valve must

always be shut OFF when the grill is not in
use.

6. The drip collector holes must be clear and

unobstructed. Excessive grease deposits can
result in a grease fi re.

7. The backburner, sideburner, or IR burner cover

must be removed before using the burner.

8. Whenever reconnecting any wires, apply a

small amount of dielectric grease to the male
connector, then make the connection.

WARNING: NEVER cover the entire cooking or grill surface with griddles or pans. Overheating will occur, and

burners will not perform properly when combustion heat is trapped below the cooking surface.

CAUTION: NEVER spray water on a hot gas unit.

GRILL MAINTENANCE AND SAFETY INFORMATION

The grill serial identifi cation number is located on the underside of the drip tray handle. It

is recommended that the drip tray fi rst be removed and cleaned / emptied of its contents,

then turned over to view. The unit rating label is located on the inside of the control panel.

REV 0 - 1412011415

L-C2-435

LIGHT SWITCH

The light switch is push button operated, and is
located on the right side of the control panel (see
Fig. 7-1). It controls the power to all lights.

ELECTRICAL CONNECTIONS

This grill requires 120VAC power to opperate.

Plug the power supply cord into a properly wired
and inspected GFCI electrical receptacle
(15 AMP
minimum). Use a heavy-duty grounded extension
cord if necessary.

WARNING

Electrical Grounding Instructions

For your protection against shock hazard, this
outdoor-cooking gas-appliance is equipped with
a three-pronged (grounding) electrical connector.
This appliance should be connected to a properly
grounded three-prong receptacle using a grounding
extension cord rated for outdoor use. Do not cut or

remove the grounding prong from the connector.

Important: ONLY REPLACE THE OVEN LIGHTS

WITH 12V / 10 WATT HALOGEN BULB(S).

Light

switch

Fig. 7-1