FiberPlex RMC-3101 - Manual (Page 8)

Features
RMC‐2101 Front Features
Figure 7 RMC‐2101 Front Face
Chassis Ventilation Fans (x2) – These fans provide forced air cooling to the mounted components.
RMC‐2101 Rear Features
Figure 8 RMC‐2101 Rear Face
Power Supply Installation Positions (x2) – The first two chassis positions are spaced appropriately for
the installation of redundant PSM‐2010 power supplies, which are hot‐swappable. FOI modules can be
placed in this position if only a single power supply is used allowing for a total of 9 FOI modules.
FOI Module Installation Positions (x8) – The remaining positions are spaced appropriately for the
installation of up to 8 FOI modules on their CMA‐2001 adapter plates.
Card Guides, Upper and Lower – Power supply and FOI modules are aligned with the guides for
proper insertion with the mating connectors in the chassis wall.
Module Grounding and Retention Fitting – All modules are equipped with a grounding lug which
engages blind into this jack upon installation. This also aids retention of each module within the
chassis.
Power Connector Jack – DC power is tapped from the power supplies and distributed to the FOI units
via these connectors on a single bus. Designed for the blind mating application, the interface provides
retention of the units as well.
1
2
3
4
5
6