FiberPlex RMC-3101 - Manual (Page 3)

Class I Equipment (Mains Operation)
Should the equipment be delivered without a matching mains cable, the latter has to be prepared by a trained person using the attached female
plug (IEC320/C13 or IEC320/C19) with respect to the applicable regulations in your country.
Before connecting the equipment to the AC power outlet, check that the local line voltage matches the equipment rating (voltage, frequency)
within the admissible tolerance. The equipment fuses must be rated in accordance with the specifications on the equipment.
Equipment supplied with a 3‐pole appliance inlet (protection conforming to class I equipment) must be connected to a 3‐pole AC power outlet so
that the equipment cabinet is connected to the protective earth.
WARNING:
If the ground is defeated, certain fault conditions in the unit or in the system to which it is connected
can result in full line voltage between chassis and earth ground. Severe injury or death can then result
if the chassis and earth ground are touched simultaneously.
Warranty, Service and Terms and Conditions of Sale
For information about Warranty or Service information, please see our published ‘Terms and Conditions of
Sale’. This document is available on
fiberplex.com or can be obtained by requesting it from
[email protected] or calling 301.604.0100.
Disposal
Disposal of Packing Materials
The packing materials have been selected with environmental and disposal issues in mind. All packing material
can be recycled. Recycling packing saves raw materials and reduces the volume of waste. If you need to
dispose of the transport packing materials, recycling is encouraged.
Disposal of Used Equipment
Used equipment contains valuable raw materials as well as substances that must be disposed of
professionally. Please dispose of used equipment via an authorized specialist dealer or via the public waste
disposal system, ensuring any material that can be recycled has been. Please take care that your used
equipment cannot be abused. After having disconnected your used equipment from the mains supply, make
sure that the mains connector and the mains cable are made useless.
Disclaimer
The information in this document has been carefully checked and is believed to be accurate at the time of
publication. However, no liability is assumed by FiberPlex for inaccuracies, errors, or omissions, nor for loss or
damage resulting either directly or indirectly from use of the information contained herein.