Introduction, Key features, Chassis model overview – FiberPlex RMC-3101 User Manual
Page 4
![background image](https://www.manualsdir.com/files/783753/content/doc004.png)
Introduction
The FiberPlex Technologies RMC‐2101 / RMC‐3101 / RMC‐3102 chassis are standard 19” rack mountable
chassis. Each chassis provides up to nine (9) available slots for any FiberPlex fiber optic isolator (FOI) or
telephone disconnect unit. Note that the size 3 and TDU units will not fit in the RMC‐2101 chassis.
The tenth available slot must be occupied by a power supply module. Each chassis will be shipped with one
power supply module (PSM). A second power supply module may also be added for system power
redundancy, leaving eight (8) available slots for the installation various combinations of FOI units. If the first
power supply module fails, the second will assume the entire system load and carry on normally. The failed
power supply module may be hot swapped with a new one without interruption of FOI operation.
Each FOI must be mated to a chassis mount adapter (CMA), which interfaces the FOI with the slot and assures
correct alignment of the isolator power connector and the chassis power bus.
Key Features
Up to nine fiber optic isolators may be mounted per chassis.
Each fiber optic isolator is accessible and removable through the front of the chassis in the RMC‐
3101 and on the rear in the RMC‐2101.
One PSM‐2010 or ‐3010 power supply and power cord is included with chassis.
Power redundancy is available through an optional second power supply module.
A cable bay is provided below the module bay for cable routing on the RMC‐3101 and RMC‐3102.
Enhanced air flow through two exhaust fans and a vented panel.
Chassis Model Overview
The following table is a summary of the various chassis models and features.
Mod
el
Nu
mb
er
RFI
Sup
p
res
sed
Power
Rack
He
ig
ht
ST
Op
ti
cal
Patch
Panel
Accommo
d
ate
Si
ze
2
&
4
FO
I
Mod
els
Accommo
d
ate
Si
ze
3
FOI
and
TDU
Mo
d
e
ls
Power
S
upp
ly
Mod
el
(1
in
cl
ud
ed
)
Ch
ass
is
Mo
unt
Ad
ap
te
r
(s
ol
d
se
pa
ra
te
ly
)
RMC‐2101
2U
X
PSM‐2010
CMA‐2001
RMC‐2101R
X
2U
X
PSM‐2010
CMA‐2001
RMC‐3101
3U
X
X
PSM‐3010
CMA‐3002
RMC‐3101R
X
3U
X
X
PSM‐3010
CMA‐3002
RMC‐3102
3U
X
X
X
PSM‐3010
CMA‐3002
RMC‐3102R
X
3U
X
X
X
PSM‐3010
CMA‐3002