ETA Digi Lancetta - Manual (Page 28)

V. REMOVING PROBLEMS
Problem Cause Solution
Iron is not heated. Power supply not connected Check the cord, plug and the socket
Display shows STAND-BY Set suitable program with control
sign
AUTO STOP function Move the iron for deactivation of the
activated safety function
Iron does not create There is no water in the Pour water into the container
steam container
Steaming regulator is Move the regulator into the steaming
in 0 position position
Low temperature is set for Set a program by the control, during
activating the DRIP-STOP which you can use steaming and wait till
function the iron is heated for using it
Iron does not create Low temperature is set for Set a program by the control, during
steam shock activating DRIP-STOP which you can use steaming and wait till
function the iron is heated for using it
The function of steam shock Let the iron heat and wait for a while
was used too often during before using the electric shock function
a short period of time again
Sprinkling equipment There is no water in the Pour water into the container
(additional spray) does container
not sprinkle water
The water system is aerated Tighten finger on the additional spray
jet hole and at the same time press the
sprinkling device button several times
Water is dripping from The lid of the pouring hole of Close the pouring hole lid
the ironing plate the container is not closed
properly.
Low temperature is set Set a program by the control, during
which you can use steaming and wait till
the iron is heated for using it
The steam shock function Set the program COTTON, MAX or PWR
was used when temperature JEANS by the control
below was set
28
GB