ETA Digi Lancetta - Manual (Page 26)

Steam ironing
Hold the iron disconnected from power supply in your hand, turn steaming regulator D
to 0 position (Fig. 5) and lift off cover C to open the filling container lid. Pour in water to
container I using the enclosed cup N (Fig. 4) and close the filling hole lid in the opposite
direction. Keep the position of the iron for pouring in water. Plug power cord M to
a socket. Put the iron into the rest position (Fig. 7) and using control H set one of the
programs enabling steaming on the display (i.e. WOOL, COTTON, MAX or PWR JEANS).
When you hear a sound signal (indicating reached selected temperature), move regulator
D towards the handle. The more you move the regulator towards MAX, the bigger amount
of outgoing steam there will be (Fig. 5). Place the iron to the rest position, automatic
creation of steam will stop (more steam may be going out for a short time).
Warning
- Be extra careful to avoid accidental pushing of the SELF CLEAN button.
- When water container I is filled with water over the permitted limit (max. 300 ml), steam
can be created even in the rest position.
- At places with hard water we recommend diluting it with distilled water. You will get the
information about water hardness at the water-management authorities, or at the local
sanitary station. For water hardness > 15 °N we recommend filling the iron in the following
ratio:
Water hardness Ratio of tap water : distilled water
medium 2 : 1
hard 1 : 1
very hard 1 : 2
Sprinkling appliance (additional spray)
It is used for moistening fabrics and it is effective in ironing extremely creased fabrics.
It is activated by repeated pressing of additional spray button E. We do not recommend
applying additional spray for fine fabrics (e.g. silk and synthetic) as the used water may
stain the fabric.
I ntensive steaming (steam shock)
Use only if the steam ironing is insufficient. In this case press intensive steaming button
F several times (Fig. 6A ). Thus you will get additional steam except for the steam
created by standard steaming.
Warning
When you press intensive steaming button F several times, water may drip from the ironing
plate due to excess water in the steam chamber. Do not consider this as faulty operation.
VERTICAL system
It is intensive vertical steaming for steaming freely hanging textiles (e.g. hanging clothes,
curtains, drapes). Using control H set one of the programs for steaming on the display
(i.e. WOOL, COTTON, MAX or PWR JEANS). When you hear the sound signal, stretch the
fabric slightly with one hand and move the iron vertically bottom-up (Fig. 6B ), at the
same time push intensive steaming button F to achieve vertical steam surge. Do not hold
the intensive steaming button pressed continuously and do not use it more than 10 times
consecutively.
26
GB