ESI SW8000 - Manual (Page 11)

management, the Satellites control should be set together with upper frequency limit of
Subwoofer Control.
If your satellites are properly damped at the bass response, the control should be selected to
the same frequency for Satellites control and Subwoofer Control.
If your satellite speakers are under-damped (“Boomy”), the control should be set to a higher
frequency and if they are over-damped (“dry”), a lower setting is best.
Note the final control setting, in case they are accidentally altered.
d. Setting of Phase control
The purpose of this control is to match the phase of satellite cut off frequency to the phase
of the upper frequency limit of the Subwoofer. Adjust the Phase control to make the
maximum sound pressure at cross over frequency in order to make sure Subwoofer and
Satellites are in phase at cross over frequency. So, you will get maximum sound pressure
and most accurate sound quality from the whole system.
8. Extra Sub Output
If you have big Studio and require higher Subwoofer sound pressure, you can use the “Extra
Sub” Output to connect as many SW8000 in daisy chain together. (Connect “Extra Sub”
Output to L or R input of another SW8000)
9. HPF Bypass switch
When you want to use SW8000 with Professional Audio Console with bass management or
in any occasion you want to have no high pass filter, you can switch the switch to “Off”.
10. Fuse Holder and Fuse
Please only replace with the exactly same type of fuse in the fuse holder.
11