ESI aktiv 05 Rev.B - Manual (Page 9)

ESI aktiv 05
9
3. vent port – aktiv 05 is a vented box speaker system with a vent port on the rear panel. Make sure
you are not blocking the vent port (i.e. by putting the speaker too close to a wall) or the sound
colour will be changed.
4. volume control knob – use the volume control knob to set the proper input level from the sound
source. Make sure to setup all speakers accordingly. When set to the center position, the output
level is set to the recommended calibrated level to reach the most optimised dynamic response
(expecting a balanced XLR +4dBu or unbalanced TS -10dBV input signal).
5. power switch – when you push the power switch, aktiv 05 will be turned on, and –surprise– it
will be turned off when you push the power switch again.
6. power port with ext. fuse – use this connector to plug in the detachable 3-circuit line cord that
connects to the power outlet. The connector contains a replaceable fuse (T1AL250V).
7. power mode switch – you can select either STANDBY or ON. When set to ON, the unit will
always be turned on. When set to STANDBY, the unit will switch to power saving mode after a
while without any audio signal. The power saving mode is indicated by a red LED on the front
panel (instead of the blue power LED). When there is an audio signal again, regular operation
resumes. Please note that the POWER MODE switch is only available in models sold in certain
countries.
5. General Information
Trademarks
ESI, aktiv and aktiv 05 are trademarks of ESI Audiotechnik GmbH. Other product and brand names
are trademarks or registered trademarks of their respective companies.
Correspondence
For technical support inquiries, contact your nearest dealer, local distributor or ESI support online at
www.esi-audio.com.
Disclaimer
All features and specifications subject to change without notice.
Parts of this manual are continually being updated. Please check our web site www.esi-audio.com
occasionally for the most recent update information.