ESI KeyControl 25 - Manual

Thank you for choosing KeyControl 25 - a 25-key USB Mobile MIDI Controller.
Connection / Power Supply / Controls
KeyControl 25 gets connected via the included USB cable to your computer. This connection
powers the keyboard and is used to transfer the MIDI data to your computer. In addition, the
MIDI data is sent out via the MIDI output port that you can connect to other devices such as a
sound module. Just connect KeyControl 25, launch and configure your favorite audio software
and start playing!
KeyControl 25 can also be used standalone when connected to an optional 9V DC power
supply (not included). In this case the MIDI data will only be sent out via the MIDI output port.
Preset Select Mode on power-up
When KeyControl 25 is first powered up, the 10 Numeric Pads are used for Preset selection.
Press Pads 0-9 to change to the desired Preset.
MIDI Program Change Mode
If the “Preset/Prog.” button is pressed, “Preset/Prog.” button LED lights up and Numeric Pads
change to Program Change Mode. Input the Program Number using the Numeric Pads and
press Enter. You can Immediately send Program Change messages by using ＋ / - button.
Change Bank (1~8/9~16)
You can change the bank of Knobs and Wheels at right side of front panel by pressing the “1-
8/9-16” button. This toggles between the banks of 1-8 and 9-16.
Panic
Press the “Panic” button if a situation occurs that all notes are stuck. This sends MIDI Note Off
messages.
Edit Mode
You can configure the KeyControl 25 operation with Edit mode using the next 3 steps:
Step1. Press “Edit” button to enter Edit mode. The Edit button LED will light.
Step2. Choose the function that you want to edit using the Numeric Pad.
Step3. Enter a value using Numeric Pad or +/- button and press the “Enter” button. Mode
returns to the initial state of Edit Mode.
* You can exit to the initial state of Edit Mode by pressing “ESC” Key during any step.