ESI MaXiO 032 - Manual (Page 42)

MaXiO series System Manual
42
6.3 Cakewalk SONAR
There are few steps to configure SONAR, which supports either WDM or ASIO drivers. After
launching SONAR, go to Options > Audio.
If you prefer the WDM/KS mode, change the settings as shown in the following picture:
Note that the input and output drivers have to match each other. Restart SONAR after the settings
have changed.
If you prefer the ASIO mode (which is supported in SONAR 2.2 and newer), first, change the
Driver Mode to ASIO on the Advanced tab of as shown below. Then restart SONAR. Note that we
recommend using ASIO instead of WDM/KS as the performance will be better.