Freestanding, Assemble a double sided solution – Elfa Freestanding User Manual

Page 4

www.elfa.com

Sida 4 av 5

Freestanding

Assemble a double sided solution

It’s best to have two people to assemble a 83”/2124 mm tall
solution.
Before you begin, make sure the levelers on each foot are screwed

all the way into the foot.
Please note that all double sided solutions require feet on both sides

of the solution.

NOTE

Insert upright into feet

–

The two holes on the side of the upright should be at
the bottom of your finished solution.

–

Line up the upright with the slot in the foot. (Figure A)
To secure, you can tap the upright and foot together on
the ground or use the mallet. Make sure the upright is
all the way into the slot on the foot. (Figure B)

–

Repeat this process with another foot on the opposite
side of the upright. Set aside. (Figure C)

–

Repeat the above three steps with another upright and
two feet.

Install crossbraces

–

— Insert one crossbrace into the top hole on the
side of the upright; insert the other crossbrace into
the bottom hole. The bent tips on the unattached
end of each crossbrace should face the same
direction. (Figure D)

–

Position the second assembled upright/feet set so
that it is perpendicular to the first set. (Figure E)

–

Attach the opposite ends of crossbraces diagonally
into the holes of the second upright. (Figure E)

–

Pull the second upright/feet set back to the forward
position (so that the feet on both sides of the solu-
tion are parallel.) This will lock the crossbraces into
place. (Figure F) diagonally into the holes of the
second upright. (Figure E)

–

Pull the second upright/feet set back to the forward
position (so that the feet on both sides of the solu-
tion are parallel.) This will lock the crossbraces into
place. (Figure F)

Assemble a double sided solution

Elfa Lumi AB

Elfagatan 5, 593 87 Västervik
Tel: +46 392-389 10 Fax: +46 392-361 25. E-mail: [email protected]