Electro-Chemical Devices (ECD) H10 - Manual (Page 2)

2
Contents
General Introduction ................................... 4
Initial Inspection ........................................... 4
Waterproof .................................................. 5
Installing the Batteries ................................. 6
Display and Key Functions ........................... 7
A. Display ..................................................................... 7
B. Keys ......................................................................... 8
Operational Procedures ............................... 9
A. Buffer Set Selection ................................................ 9
B. pH Calibration ......................................................... 9
Calibration with an ATC/Temp probe in the pH‐
AUTOLOCK mode .................................................... 9
Calibration with manual temperature
compensation in the pH‐AUTOLOCK mode .......... 10
Calibration with an ATC/Temp probe in the pH
NON‐AUTOLOCK mode ......................................... 11
Calibration with manual temperature
compensation in the pH NON‐AUTOLOCK mode .. 12
C. pH Measurements ................................................ 13
Measurement with an ATC/Temp probe in the pH
AUTOLOCK mode .................................................. 13
19
Warranty
Electro‐Chemical Devices, Inc. (ECD) warrants all products it
manufactures to be free from defect in materials and factory
workmanship, and agrees to repair or replace any product that fails
to perform, as specified, within one (1) year after date of shipment.
This warranty shall not apply to any product that has been:
1. Subjected to misuse, negligence or accident;
2. Connected, installed, adjusted or otherwise used not in
accordance with the instructions furnished by ECD;
3. Repaired, modified or altered by persons not authorized
by ECD, resulting in injury to the performance, stability or
reliability of the product.
This warranty is in lieu of any other warranty, expressed or implied.
ECD reserves the right to make changes in the design or construction
of its products at any time, without prior notification, and without
incurring any obligation to make any changes in previously delivered
products.
Seller’s sole liabilities and the buyer’s sole remedies under this
agreement shall be limited to a refund in the purchase price, or at
ECD’s discretion, to the repair or replacement of any product that
proves, upon ECD’s examination, to be defective, when returned to
the factory, transportation prepaid by the buyer, within one (1) year
of the product’s original shipment date. Seller shall not be liable for
damages consequential or incidental to defects in any product, for
failure of delivery in whole or in part, for injuries resulting from its
use, or for any other cause.
This warranty and the writing attached constitute the full
understanding of seller and the buyer, and no terms, conditions,
understanding, or agreement purporting to modify or vary the terms
hereof shall be binding unless hereafter made in writing and signed
by an authorized official of Electro‐Chemical Devices, Inc.
This warranty does not cover pH, ORP or Specific Ion measurement,
reference or combination electrodes or electrode cartridges that
have been commissioned in service.
If service or repair is required, please obtain the serial number(s) or
sales order number of the product(s) in question and contact ECD’s
Service Department at: +1‐800‐729‐1333 (USA/Canada) or +1‐949‐
336‐606