Dimplex DFB8842 - Manual (Page 16)

16 www.dimplex.com
Remove four (4) Phillips 2.
screws from right side of trim
(Figure 7).
remove trim.
3.
Slide glass to right side of 4.
fireplace to remove (Figure 7).
Pull the front edge of the
5.
plastic Log set or plastic grate
up and forward until the rear
tab releases from the ledge
located at the bottom of the
mirror (Figure 8).
!
IMPORTANT: Only handle
the Log Set Assembly by the
Ember Bed or plastic grate.
!
NOTE: Log set Assembly fits
tightly into firebox, some force
may be necessary to remove.
Set Log Set Assembly in front 6.
of fireplace.
unscrew bulbs counter
7.
clockwise.
Insert new bulbs and screw in 8.
clockwise.
Install the Log Set Assembly
9.
by placing the front, bottom
edge of the Ember Bed in the
track behind the control panel.
once in place, push down on
the back edge of the Ember
Bed until the rear tab snaps
into place under the mirror
(Figure 8).
!
NOTE: Ensure the Log set
Assembly is installed tightly
under the back ledge to
prevent light leakage.
slide front glass back into
10.
position and attach trim.
Upper Light Bulb Requirements
Quantity of two (2) clear
chandelier or candelabra bulbs
with an E-12 (small) socket base,
15 Watt rating.
Do not exceed 15 Watts per
bulb.
To access the upper light bulb
area:
slide fireplace out of mantel. 1.
Remove four (4) Phillips 2.
screws from right side of trim
(Figure 7).
remove trim.
3.
Maintenance
Back
Ledge
Log
Ember Bed
Rear
Tab
Front
Edge
side section
Figure 8