3 before operating, 4 operation safety, 5 maintenance/storage safety – Echo Bear Cat WV190S 2009 User Manual
Page 6

WHEELED VACUUM
2
SAFETY
1.4 opERaTIoN SaFETY
1.5 maINTENaNcE/SToRaGE SaFETY
Before inspecting, servicing, storing, or changing
1.
an accessory, shut off the machine and make sure
all moving parts have come to a complete stop.
disconnect the battery and remove the ignition key
where applicable.
replace any missing or unreadable safety decals.
2.
refer to the safety decal section for part numbers.
allow machine to cool before storing in an enclosure.
3.
Store the machine out of reach of children and where
4.
fuel vapors will not reach an open flame or spark.
Never store this machine with fuel in the fuel tank
5.
inside a building where fumes may be ignited by an
open flame or spark. ignition sources can be hot water
and space heaters, furnaces, clothes dryers, stoves,
electric motors, etc.
drain the fuel and dispose of it in a safe manner for
6.
storage periods of three months or more.
Set up your work site so you are not endangering traffic
1.
and the public. Take great care to provide adequate
warnings.
Keep the machine clear of debris and other
2.
accumulations.
do not allow processed material to build up in the
3.
discharge area. This may prevent proper discharge
and can result in kickback of material through the feed
opening.
if the machine becomes clogged, or the machine
4.
starts vibrating or making an unusual noise, shut off
machine immediately and make sure all moving parts
have come to a complete stop. disconnect the battery
and remove the ignition key if applicable. after the
machine stops: a) inspect for damage, B) replace
or repair any damaged parts, and C) Check for and
tighten any loose parts.
do not tamper with the engine governor settings on
5.
the machine. The governor controls the maximum safe
operating speed and protects the engine and all moving
parts from damage cause by excessive speed.
1.3 bEFoRE opERaTING
read and understand this owner’s manual. Be
1.
completely familiar with the controls and the proper
use of this equipment.
familiarize yourself with all of the safety and operating
2.
decals on this equipment and on any of its attachments
or accessories.
Keep safety decals clean and legible. replace missing
3.
or illegible safety decals.
obtain and wear safety glasses
4.
and use hearing protection at
all times when operating this
machine.
avoid wearing loose fitted
5.
clothing. Never operate this
machine while wearing clothing
with drawstrings that could wrap around or get caught
in the machine.
do not operate this machine if you are under the
6.
influence of alcohol, medications, or substances that
can affect your vision, balance or judgement. Do not
operate if tired or ill. you must be in good health to
operate this machine safely.
do not operate this equipment in the vicinity of
7.
bystanders. Keep the area of operation clear of all
persons, particularly small children. it is recommended
that bystanders keep at least 50 feet (15 meters) away
from the area of operation.
do not allow children to operate this equipment.
8.
use only in daylight or good artificial light.
9.
do not run this equipment in an enclosed area. engine
10.
exhaust contains carbon monoxide gas, a deadly
poison that is odorless, colorless and tasteless. do not
operate this equipment in or near buildings, windows
or air conditioners.
always use an approved fuel container. do not remove
11.
gas cap or add fuel when engine is running. add fuel
to a cool engine only.
do not fill fuel tank indoors. Keep open flames, sparks,
12.
smoking materials and other sources of combustion
away from fuel.
do not operate machine without shields in place.
13.
Failure to do so may cause serious injury or death.
Keep all guards, deflectors, and shields in good
14.
working condition.
Before inspecting or servicing any part of this machine,
15.
shut off the machine and make sure all moving parts
have come to a complete stop. disconnect the battery
and remove the ignition key where applicable.
Check that all screws, nuts, bolts, and other fasteners
16.
are secured, tightened and in proper working condition
before starting the machine.
do not transport or move machine while it is operating
17.
or running.
- WV190 2009 WV179S 2009 WV179 2009 WV160S 2009 WV160 2009 WV190S 2008 WV190 2008 WV179S 2008 WV179 2008 WV160S 2008 WV160 2008 77360 77060 75360 2008 75060 2008 WV190S 2010 WV160S 2010 WV160 2010 WV190S 2014 WV190 2014 WV160S 2014 WV160 2014 WV190S 2011 WV190 2011 WV160S 2011 WV160 2011 WV190S 2013 WV190 2013 WV160S 2013 WV160 2013 WV190 2010