Echo Bear Cat 70580 v.1 - Manual (Page 14)

3 INCH CHIPPER/SHREDDERS
12
Section
understanding how your machine works will help you achieve
the best results when using your chipper/shredder. The following
descriptions define the features and controls of your machine.
3.2 engine ThroTTle
modelS: all modelS
Changes engine speed. Push lever to 1/2 throttle for starting.
Push lever to slow for idle and warm-up. Push throttle lever to
slow throttle to shut engine off. Refer to engine manual for further
engine operating instructions. When chipping or shredding, the
engine should be at full throttle.
3.3 engine choke
modelS: all modelS
use when starting a cold engine. move lever to the choke position
when starting. move lever to the run position when engine is
running (Figures 3.3 and 3.4). Refer to engine manual for further
engine operating instructions.
3.1 engagemenT handle
modelS: all modelS
during engine start-up, the engagement handle must be in the
disengaged position (Figure 3.1). With engine at full throttle,
carefully engage the rotor by slowly pushing the engagement
handle down, allowing the rotor to speed up gradually (Figure
3.2). Engaging the clutch too quickly with the engine at full or
half throttle will bog down the engine and will shorten the life of
the belt. To disengage the rotor, first idle the engine down and
then lift the engagement handle up
3
features & controls
Figure 3.3
Briggs Throttle and
Choke Locations
Figure 3.1
Disengaged Clutch
Figure 3.2
Engaged Clutch
Figure 3.4
Honda Throttle and
Choke Locations