Echo Bear Cat 73554 - Manual (Page 16)

Page 13 Bearcat Chipper Shredder Operator’s Manual
Assembly
1. Attach the blower discharge tube
to the mounting flange on the chipper
frame.
2. Slide the tube into the flange and
tighten the bolts to secure it.
STEP 1: ATTACH THE BLOWER DISCHARGE TUBE
3. Install the second half of the clamp
to the tube and flange. 4. Grease the chute to allow free ro-
tation. Rotate the tube 360 degrees
and lock it in place with the handle to
make sure it is mounted correctly.
MODEL # 73554 ASSEMBLY INSTRUCTIONS:
1. Slide the chipper extension into the
chipper chute aligning the mounting
holes.
STEP 2: ATTACH THE CHIPPER EXTENSION
(MUST BE INSTALLED TO MEET EUROPEAN REQUIREMENTS)
2. Secure using four 5/16 X 3/4” car-
riage bolts, 5/16” nylock nuts and 5/
16 flat washers.
STEP 3: ATTACH THE SHREDDER CHUTE EXTENSION TRAY
1. Attach the shredder chute with the
supplied four 5/16” X 3/4” carriage
bolts, 5/16 nylock nuts and 5/16” flat
washers.
1. Connect the PTO implement end
to the rotor shaft using key stock and
two set screws contained in the own-
ers kit.
STEP 4: CONNECT THE PTO DRIVELINE
2. Check all screws, bolts, and nuts
for tightness. See torque chart near
back of this manual for correct tight-
ness.