Echo Bear Cat 73554 - Manual (Page 14)

Page 11 Bearcat Chipper Shredder Operator’s Manual
MODEL # 73525 ASSEMBLY INSTRUCTIONS:
STEP 1: ATTACH THE TRAILER WHEELS
STEP 2: ATTACH THE HITCH
Section
2
Assembly
1. Hold one wheel to a hub and align
the wheel lug holes with the hub lug
holes.
1. Insert the adjustable hitch into the
hitch channel on the trailer bottom.
2. Thread the lug bolts into the holes
and tighten to 75 ft. lbs. Follow a star
pattern when tightening lug bolts. 3. Repeat for the remaining wheel.
2. Insert a 3/8 x 3-1/2" bolt through
the bolt hole in the adjustable hitch. 3. Secure with a washer and nut.
4. Place the jack stand on the side of
the hitch and secure with the snap pin.
STEP 3: ATTACH THE SHREDDER CHUTE EXTENSION TRAY
1. Attach the shredder chute with the
supplied four 5/16” X 3/4” carriage
bolts, 5/16 nylock nuts and 5/16” flat
washers.
1. Attach the blower discharge tube
to the mounting flange on the chipper
frame.
2. Slide the tube into the flange and
tighten the bolts to secure it.
STEP 4: ATTACH THE BLOWER DISCHARGE TUBE
3. Install the second half of the clamp
to the tube and flange. 4. Grease the chute to allow free ro-
tation. Rotate the tube 360 degrees
and lock it in place with the handle to
make sure it is mounted correctly.
1. Slide the chipper extension into the
chipper chute aligning the mounting
holes.
STEP 5: ATTACH THE CHIPPER EXTENSION
(MUST BE INSTALLED TO MEET EUROPEAN REQUIREMENTS)
2. Secure using four 5/16 X 3/4” car-
riage bolts, 5/16” nylock nuts and 5/
16 flat washers.