Drake SCT2x4 BBT Transcoder - Manual (Page 8)

8 Setup and Programming / Software Flow Chart
Programming and viewing of the various setup and operating parameters is accomplished using the front panel
back lit, two line, sixteen character wide LCD along with the two Left and RiGHt SeLeCt buttons and the
five Left, RiGHt, UP, DowN and eNteR buttons. the name of the parameter is on the top line of the display
and the setting value is on the bottom line.
to observe a certain parameter setting without intending to change its value, just use the Left and RiGHt
SeLeCt buttons and the Left and RiGHt arrow buttons to navigate through the menus shown in the
software flow chart below. the current setting for each parameter is shown on the bottom line of the display.
Note that depending upon certain settings, some screens are not needed and will be skipped. to make a
change in the displayed parameter and its setting and if this is the initial setup, you will want to enter the
‘adjust’ mode. to do this, press the eNteR button that is located in the center of the four arrow buttons and
hold in for several seconds until the bottom line of the display begins to flash.
After you are in the adjust mode (bottom line of screen flashing) use the Left and RiGHt arrows to navigate
among screens and use the UP and DowN arrows to change the parameter setting. when eNteR is pressed,
the new settings will be loaded and stored and the unit will exit the ‘adjust’ mode. you may wish to not press
eNteR until you have gone through all screens and settings and then press eNteR to save and load all
changes in one step, oR you can store just one or several parameters at a time and reenter adjust mode to
set the next. either method is acceptable.