Drake SCT2x4 BBT Transcoder - Manual (Page 7)

7 Rear Panel Connections
R1, RF OUTPUT – this type "f" connector is the high level (+55 dBmv), 54 to 1002 mHz, output from the
SCt2x4 upconverter section.
R2, DATA ASI OUTPUT - this BNC type connector provides a data output that can be used to direct satellite
delivered data such as emm streams to the local headend. may not be used in your system.
R3, QAM1, QAM2. QAM3, & QAM4 ASI OUTPUTS - these four BNC type connectors deliver the same four
qAm multiprogram transport streams that are fed to the Rf oUtPUt.
R4, ASI INPUT - this BNC type connector provides an ASi input where additional locally generated programs
can be input. may not be used in your system.
R5, L BAND SAT1 and SAT 2 INPUTS - these “f” type connectors provide connection to two separate LNBs
for satellite input. the user may determine if LNB voltage is supplied through these connectors as determined
by software settings.
R6, RS232 IN - Connection to a PC or modem for use with remote control / monitoring program or for firmware
download.
R7, RS232 OUT - Loop to another SCt2X4 or other RS232 controllable device.
R8, AC Line Cord – for connection to the nominal 120 vAC power source. this unit is designed for use
in countries with 120 vAC power standards but the power supply will accept an input voltage range of 90
vAC minimum to 260 vAC maximum with a power line frequency of either50 or 60 Hz. the maximum power
consumption is 85 watts.