Drake PEG-NE24 Encoder - Manual (Page 9)

9 937.746.4556 | www.rldrake.com
FRONT PANEL
1. Ethernet Control: 10/100 Ethernet wired connection for local and remote management
2. IP Reset Button: When pressed for >2 seconds, the IP address of the control port will enable to the default factory IP
address (
172.16.70.1 , Subnet Mask 255.255.255.0) The login credentials will also be enabled to the default username
admin and password pass.
Note: The old IP address, login, and password will still be present in the encoder settings.
3. Status LEDs: Provides a status of tasks performed by the PEG encoder in real-time:
Power: The LED is illuminated when the power is ON.
Input: The LED is illuminated when input video is being received from the HD/SD SDI or Composite input.
Encoding: The LED is illuminated when the internal encoder is operational.
Output: The LED is illuminated when the copper or optical SFP is connected to a network.
REAR PANEL
HD-SDI IN: Digital video HD/SD SDI input source
SFP Ethernet Output: Optical or Copper SFP IP video and audio output
5VDC Power Port: Accepts five-volt power to the device
NTSC Composite Video/Audio In: Analog video with Left and Right Audio. PEG-NE-24-IP-C model only.
1
2
3
4
5
6
7
8
Front and Rear Panel Operation
1 2 3 4 5 6 7 8