Drake PEG-NE24 Encoder - Manual (Page 10)

10 937.746.4556 | www.rldrake.com
Login Screen
First, connect the appropriate input and output video cables and plug in the PEG-NE24 power cable.
ETHERNET ACCESS:
Local or remote communication with the unit is only possible through a GUI-based menu via any standard web browser
Chrome or Firefox is recommended, for IE use IE8 minimum. Before you can communicate with the unit you must
configure your computers Local Area Network connection to confirm with the PEG default IP of 172.16.70.1. To do so,
follow these steps:
Connect an Ethernet cable from your computer to the Control 10/100 port of the PEG.
1. The following steps explain how to do this for a computer with windows XP operating software:
a) On your computer, open the "Control Panel"
b) Double-click on "Network Connections"
c) Right-click on the "Local Area Connection", and then click on the "properties".
d) A dialog box entitled "Local Area Connection Properties" will appear. In this box, double-click on the "Internet
Protocol (TCP/IP)".
e) A dialog box entitled "Internet Protocol (TCP/IP) Properties" will appear. Select the "Use the following IP address"
option and enter the following addresses:
IP address: 172.16.70.2
Subnet mask: 255.255.255.0
No need to enter a value for the Default Gateway.
Click OK to close the dialog box. Now your computer is ready to communicate with the unit.
2. The following steps explain how to do this for a computer with windows 7 operating software:
a) On your computer, open the "Control Panel"
b) Click on “Network and Internet”
c) Click on the "View network status and tasks"
d) Click on “Change Adapter Settings” on left hand side of the window
e) Right-click on the "Local Area Connection", and then click on the "Properties".
f) A dialog box entitled "Local Area Connection Properties" will appear. In this box, double-click on the "Internet
Protocol Version 4 (TCP/IPv4)".
g) A dialog box entitled "Internet Protocol Version 4 (TCP/IPv4) Properties" will appear. Select the "Use the following
IP address" option and enter the following addresses:
IP address: 172.16.70.2
Subnet mask: 255.255.255.0
No need to enter a value for the Default Gateway.
Click OK.
Open a web browser on your computer and enter the following URL address (http://172.16.70.1). Once the PEG web
server has been loaded from your browser, you should see the login dialog. Enter the username and password and
click LOG IN. The default username is " admin" (in lower case letters) and the default password is "pass" (in lower case
letters).