DR Power Backhoe 2008 - Manual (Page 42)

38 DR ®
DIRT BOSS™ TOWABLE BACKHOE
4. Remove the Bucket and position the accessory Bucket
or Digging Tooth at the same orientation as the
original Bucket.
5. Install the two Linkage Pins into the Bucket or Digging
Tooth and Linkage (Figure 39).
NOTE: Do not hammer directly on the Linkage Pin. Use a block of
wood so you do not damage the end of the Pin. Make sure the holes
in the Linkage Pins are aligned with the holes in the Accessory.
6. Install the four Bolts into the Linkage and Bucket or
Digging Tooth and secure with four Locknuts (Figure
40).
If you have any questions or need assistance, Please contact us
at www.Drpower.com or call toll free 1-800-DR-OWNER (376-
9637).
Figure 39
Linkage
Pin
Accessory
(Digging
Tooth
Shown)
Wood
Block
Figure 40
Bolt and
Locknut